____________________________________________________________________
G1000 System Maintenance Manual
Page 10-5
190-00903-00
Rev.
A
1.
Select the GTX page group, then select the Transponder Configuration page using the
small FMS knob on the PFD.
2.
Ensure that the ‘ADDRESS TYPE’ is ‘US TAIL’ under the ‘SET’ and ‘ACTIVE’
columns.
3.
Activate the cursor and highlight the ‘ADDRESS’ field. Use the small/large FMS knobs
to enter the aircraft registration number.
4.
Once the correct registration number is entered, press the ENT key. The transponder is
configured:
5.
The transponder then alerts the technician of the completed configuration:
6.
Press the ENT key on the PFD and deactivate the cursor.
NOTE
To enter a non-US Mode-S registration number set the ‘ADDRESS
TYPE’ to ‘HEX ID’ and enter the Mode-S registration number in the
‘ADDRESS’ field. Ensure the ‘FLIGHT ID TYPE’ is set to ‘CONFIG
ENTRY’ or ‘PFD ENTRY’. The CONFIG ENTRY allows the Aircraft
Registration/ID number to be entered once and stored in memory by
entering the Registration/ID number in the ‘FLIGHT ID’ field. PFD
ENTRY allows the pilot to enter the Registration/ID number from the
PFD, via the ‘TMR/REF’ softkey.