____________________________________________________________________
Page 5-124
G1000 System Maintenance Manual
Rev. A
190-00903-00
In the Aircraft:
1.
Power down PFD1 and MFD:
•
AVIONICS Switch (BUS 1 and BUS 2) – Off
•
MASTER Switch (BAT) – Off
•
STBY BATT Switch – Off
On the PC:
1.
Insert the SD Card into the card reader.
2.
Run the HSCM.exe program (verify interface resembles Figure 5-40).
Figure 5-40. HSCM Offset Tool User Interface DIsplay
3.
Select the name of the applicable aircraft in the Select Aircraft field. Standby Battery
Ammeter is the only selection available in the Select Channel field.
4.
Enter the value of READING #2 in the Input Offset Error in Amps field.
5.
Verify the drive letter of the SD card reader is selected in the Select SD Card Drive Letter
field.
6.
Press the Create Correcting Config File button.
7.
Press OK to acknowledge the pop-up box.
8.
Verify the pop-up box annunciates “aircraft name file written to drive” and press OK to
acknowledge.
9.
Press the Close button.
10.
Remove the SD card from the card reader.
In the Aircraft:
1.
Insert the SD card into the upper card slot of the PFD.
2.
Power up MFD and PFD1 in Configuration mode:
•
MASTER Switch (BAT) – On
