Fujitsu M2488, Руководство по эксплуатации продукта

Страница: 445 / 528

M2488 PRODUCT GUIDE DIAGNOSTIC TESTS AND ERROR CODES
April 1997 CG00000-011503 REV. A F-45
0x13
0x01 Write Hi_data parity error check 0xA3 SPC interrupt/step code did not report Diag-
nostic Self-Test passed
0xA4 The SPC interrupt request could not be
cleared
0x01 Bad SPC write initialization status.
0x02 Incorrect SPC SCSI control signal status wait-
ing for REQ signal assertion.
0x03 Incorrect SPC SCSI control signal status wait-
ing for REQ signal deassertion.
0x04 Error reported by record manager attempting
to request buffer for write clear SG-bypass.
0x05 Data transfer length error reported by SPC.
0x06 Expected data parity error on high byte of the
DMA bus from SPC failed to be reported by
SDDP.
0xB0 SPC did not generate an interrupt request
0xB1 SPC interrupt was not detected at the Interrupt
Request Controller
0xB2 The SPC interrupt was cleared while clearing
the Interrupt Request Controller.
0xB3 SPC interrupt/step code did not report Diag-
nostic Self-Test passed
0xB4 The SPC interrupt request could not be
cleared
0x13 0x02 Read Hi_data parity error check 0x01 Failed to receive data end-of-transfer signal in
SDDP hdxs register.
0x02 Incorrect SPC SCSI control signal status wait-
ing for REQ signal assertion.
0x03 Incorrect SPC SCSI control signal status wait-
ing for REQ signal deassertion.
0x04 Data transfer length error reported by SPC
0x05 SPC did not generate an interrupt request
0x06 SPC interrupt was not detected at the Interrupt
Request Controller
0x07 The SPC interrupt was cleared while clearing
the Interrupt Request Controller.
0x08 SPC interrupt/step code did not report Diag-
nostic Self-Test passed
Table F-15. Routine 13 - EDRC Error Detection Diagnostic Error Codes (Continued)
ROUTINE TEST TITLE
ERROR
CODE
DESCRIPTION
DIA
GNOS
TIC
TES
TS
AND E
R
R
O
R
C
O
DES