Fujitsu M2488, Руководство по эксплуатации продукта

Страница: 358 / 528

MAINTENANCE AND SERVICING M2488 PRODUCT GUIDE
8-48 CG00000-011503 REV. A April 1997
8-11.6 DTC PCBA Remove and Replace Procedures
Refer to Figure 8-8 for location of the DTC PCBA.
Do not exchange the lithium battery on the DTC PCBA.
8-11.6.1 DTC PCBA Removal
8-11.6.2 DTC PCBA Replacement
STEP ACTION
1 Remove the IPM as described in paragraph 8-11.3.1 on page 8-45.
2 Remove the top cover as described in paragraph 8-11.4.1 on page 8-46.
3 Remove the five screws from the controller.
4 Disconnect the connectors CNP05, CNJ02, and CNJ03 on the DTC PCBA. CNJ02 and CNJ03 are
on the underside of the board.
5 Remove the DTC board.
STEP ACTION
1 Place the DTC PCBA component side down on the drive.
2 Connect the connectors CNP05, CNJ02, and CNJ03 on the DTC PCBA. CNJ02 and CNJ03 are on
the underside of the board and should be gently pushed onto the mating plugs.
3 Place the five screws into the board, aligning the board with all screw holes. Tighten the five screws
into the board. Be careful not to bow the board while tightening the screws.
4 Replace top cover as described in paragraph 8-11.4.2 on page 8-46.
5 Replace the IPM as described in paragraph 8-11.3.2 on page 8-45.
CAUTION
**************** **
* *
****************