Fujitsu M2488, Руководство по эксплуатации продукта

Страница: 198 / 528

TAPE UNIT SCSI COMMANDS M2488 PRODUCT GUIDE
4-116 CG00000-011503 REV. A April 1997
4-3.26.3 REWIND Sense Keys
One of the following sense keys may be returned if a CHECK CONDITION was indicated:
SENSE KEY CONDITION DESCRIPTION
1h RECOVERED ERROR 1. Recovery was performed when writing buffered data before the
rewind occurred.
2. Retries were needed to complete the rewind operation.
2h NOT READY Logical Unit was not ready. The tape cartridge was not loaded or
the logical unit was not made ready.
3h MEDIUM ERROR 1. Write of buffered data failed due to a defective tape.
2. An attempt was made to write 36-track data on 18-track format-
ted medium.
4h HARDWARE ERROR 1. Write of buffered data failed due to a hardware failure.
2. The rewind operation was not completed because of a hardware
failure.
5h ILLEGAL REQUEST 1. Illegal parameter was found in REWIND command CDB. The
rewind operation was not performed.
2. The Flag bit was set but the Link bit was not set.
6h UNIT ATTENTION Indicates the REWIND command was not performed due to one
of the following:
1. The tape cartridge may have been changed.
2. The target has been reset.
3. The Mode parameters have been changed by another initiator.
4. The version of the microcode has been changed (microcode
downloaded).
5. A cartridge was loaded with a tape length that is too long or too
short.
Bh ABORTED COMMAND REWIND command was aborted. The REWIND command can be
reissued.
Dh VOLUME OVERFLOW Write of buffered data prior to the Read Reverse operation failed
because physical End-of-Tape has been reached.