Froling TURBOMAT TM 150, Руководство по установке

Страница: 3 / 67

4.5.14 Fitting the door contact switch 39
4.5.15 Fitting the WOS Drive 40
4.5.16 Installing the grate drive 41
4.5.17 Installing the stoker unit 42
4.5.18 Installing the induced draught fan 43
4.5.19 Fitting the primary and secondary air servo motors 45
4.5.20 Fitting the cover on the slide-on duct 46
4.5.21 Installing the underpressure controller 47
4.5.22 Installing the automatic ignition 47
4.5.23 Installing the combustion chamber overpressure and temperature sensors 48
4.5.24 Fitting the temperature sensor under the moving grate 49
4.5.25 Fitting the broad band probe and flue gas sensor 49
4.5.26 Assembling the FGR (optional) 50
4.5.27 Fitting the covers to the back of the heat exchanger 53
4.5.28 Fitting the insulated doors and the ash container to the combustion chamber 54
4.6 Power connection and wiring 55
4.6.1 Potential equalisation 55
4.6.2 Fitting the insulation cover and the cover plate 56
4.7 Connecting up thermal discharge safety sensor connection 57
4.8 Connecting up the slide-on duct cooling 58
4.9 Final installation steps 59
4.9.1 Setting and testing the seal on the combustion chamber doors 59
Checking the settings of the door stop 59
Checking the settings of the door handle 59
Checking the door stop seal 60
Checking the door handle seal 60
4.9.2 Adjusting the combustion chamber doors 61
Door stop side 61
Door handles 61
5 Commissioning 62
5.1 Before commissioning / configuring the boiler 62
5.2 Initial startup 63
5.2.1 Permitted fuels 63
Wood chips 63
Wood pellets 63
Wood shavings
63
Miscanthus
64
Changing the fuel
64
5.2.2 Non-permitted fuels 64
5.3 Heating up for the first time 65
6 Decommissioning 66
6.1 Out of service for long periods 66
6.2 Disassembly 66
6.3 Disposal 66
7 Appendix 67
7.1 Addresses 67
7.1.1 Address of manufacturer 67
7.1.2 Address of the installer 67
Table of Contents
Installation Instructions | M0650314_en 3