4.5 Installing the boiler
NOTICE
Reduction in performance due to air leakage
The use of flanges without sealing cords can result in a reduction in performance
due to air leakage
Therefore:
❒ Sealing cords or the surface sealant provided must be used on all the flanged
connections on the following components: loading; ash removal; pressure
ducting; air ducts; combustion air fan; flue gas and flue gas return piping.
4.5.1 General information
Front and back of boiler
The front of the boiler is its operating side. All of the operating controls for the combus‐
tion chamber door, ash can, control cabinet and other components are on the front of
the unit.
The back of the boiler is opposite the front The stoker unit, EOS drive and complete
flue gas system are on the back of the boiler.
Heat exchanger on the left or right
The heat exchanger of the Turbomat can be on the left or the right (when seen from
the front, operator side) of the combustion chamber. Before you start installation,
check if the heat exchanger is to be installed on the left or the right. In some cases this
is already indicated on the layout drawing.
Version: Heat exchanger left
Version: Heat exchanger right
1
Combustion chamber
2
Heat exchanger
4
Installation
Installing the boiler
18
Fröling GesmbH | A-4710 Grieskirchen, Industriestraße 12 | www.froeling.com
