5. Diagnosis and error treatment
5-12
Festo P.BE-SPC11-SYS-ASI-EN en 0203NH
(A.02)
4. With the b/- you can increase or reduce the value
by one stage, in accordance with the positioning char-
acteristics of the drive (see axis-specific supplement).
Hold the Enter key pressed down for at least 2 seconds
(
>
2 s) in order to accept the value. The cushioning stage
will then be shown.
(C.04)
5. With the b/- you can increase or reduce the value
by one stage, in accordance with the positioning char-
acteristics of the drive (see Axis-specific supplement).
Hold the Enter key pressed down for at least 2 seconds
(
>
2 s) in order to accept the value. The system parameter
will then be shown.
(S.01)
6. Check and, if necessary, correct the current setting. Hold
the Enter key pressed down for at least 2 seconds (
>
2 s)
in order to accept the value. The SPC11 then indicates
readiness to carry out the teach procedure (t flashes).
The t flashes.
Please note
During the teach procedure, the moveable mass moves at
first slowly, then at the highest possible acceleration and
speed. Make sure that:
– nobody can place his/her hand in the positioning range
of the moveable mass, unless the compressed air supply
is switched off.
– the complete positioning range is free of any objects.
Содержание Soft Stop SPC11 Series
