FEC AFC3000, Руководство по эксплуатации оборудования

Страница: 98 / 294

Chapter 4 Installation and Wiring
PAGE 4-35

BYPASS : Spindle off signal (Normally Open)
When active (on), all functions of the spindle controller are disabled and a BYPASS signal is
output, making it impossible to start the spindle.
If the signal becomes active during a fastening cycle, the fastening cycle is stopped.

SELF CHECK OFF : Torque Transducer automatic check “OFF” signal
When this signal is “OFF” (or unconnected) at the time of inputting a START signal, the zero
voltage level and CAL voltage level of the torque transducer is automatically checked before
the fastening cycle begins.
If the automatic check of the torque transducer is not required, turning “ON” this signal at the
time of inputting a START signal will cause this test not to be performed.
Once a Self Check is completed, the unit holds the check value until control power is turned
off.

BANK SELECT : Bank Select signal
For a Single System: When this signal is “ON” all of the outputs will be turned off.
For a Multi System (Master Spindle): When this signal is “OFF”, outputs will reflect the
System status. When this signal is turned “ON”, outputs will reflect the Master spindle status.