FEC AFC3000, Руководство по эксплуатации оборудования

Страница: 266 / 294

Chapter 9 Maintenance & Inspection
PAGE 9-7
9-3 Replacements
WARNING:
DO NOT CONNECT OR DISCONNECT CABLES OR OTHER SYSTEM COMPONENTS WITH
POWER APPLIED . FOLLOW LOCKOUT/TAGOUT AND OTHER APPLICABLE SAFETY PRECAUTIONS.
NOTE: When replacing the AFC3000 System controller, ensure that the new unit is configured with the
compatible Hardware and Firmware version as the unit being replaced. The Firmware Version number will
show in the Data Display when the Parameter number displays “SYS” and the D-NO displays “001”.
Newer firmware versions will provide compatibility with older firmware versions under most instances. When
the system requires special firmware due to customer requirements, care should be taken to ensure Spare
units are ordered with the Firmware version identified.
9-3-1 MFC Unit
Do not attempt to replace a component of the tool - the tool must be replaced as a complete assembly.
When one MFC Unit is being replaced with another, it is important to verify that both units are the same
type.
Unit Replacement Procedures
1. Verify the enclosure power is off. Ensure all cables connected to the MFC unit are clearly marked
(for reconnection).
2. Disconnect all cables from the unit.
3. Loosen (do not remove) the three (3) screws that secure the MFC unit to the back panel. The
upper bracket of the MFC unit has one slotted hole and the bottom bracket has two open-ended
slots.
4. Lift up and out on the unit to remove.
5. Verify the new MFC unit’s rotary address switches are set to the appropriate spindle number and
Special Function Switches SW1 and SW2 reflect the correct configuration (as the unit being
replaced). Refer to Section 4-12.
6. Verify the MFC Units have the same configuration (hardware and software).
7. Install the new MFC unit in reverse order of removal.
8. Apply power to the enclosure. After approximately 7 seconds, the System will finalize the Power
On Self Test (POST).
9. The MFC unit WILL require re-entry of the preset data. Refer to Chapters 7 and 8.
Although the fastening parameters can be set from the display device on the unit,
using the AFC3000 User Console can shorten the restoration time because the
setting value can be written on the unit by using the fastening parameters setting
file.
The following setting items are required to set manually.
・ ・ ・ ・
Spindle No. Rotary Address Switches
・
・ ・
・
Special Function SW1Switch
：
： ：
：
No.8 “Communication Station Specifications”
・ ・ ・ ・
Par No. “SYS”, D-No. “003” (System Indication)