FEC AFC3000, Руководство по эксплуатации оборудования

Страница: 217 / 294

Chapter 8 System Operation
PAGE 8- 10
8-3-3 Fastening Result Display Mode
The following data is displayed in Fastening Result Mode. In the fastening result mode, “r.” is indicated at
the 100s digit of the PAR No. indication part and the parameter No. (01 to 32) of the fastening operation that
was performed is indicated by the 10s and 1s digits. By pressing the [ ▲ ] or [ ▼ ] push-button, the “D-NO”
can be changed ±1. The numbers can be advanced 5 at a time by holding the [
▲
] or [
▼
] push-button longer.
*If fastening has not been started, “r.00” is displayed.
PAR No. D-No. DATA Unit
r.01~32
000
Peak Torque H/L Nm
001
Final Angle H/L deg
002
Rate 1 H/L Nm/deg
003
Rate 2 H/L Nm/deg
004
Rate 3 H/L Nm/deg
005 1 ST Time H/L sec
006 2 ND Time H/L sec
007 Cycle Time sec
008
Differential Angle H/L deg
009
Fastening Result
reject
：
REJECT(Fastening NG)
accept
：
ACCEPT(Fastening OK)
abn
：
Stop by ABNORMAL(Abnormal occurs) signal
stop
：
Stop by loss of the STOP (Emergency Stop) Signal
reset
：
System clear by RESET(Reset) Signal
bypass
：
Stop by BYPASS(Bypass) Signal
st-off
：
START signal loss during BUSY (while operating) signal
010 1st NG item (The D-No. of the fastening NG item that occurred first is displayed)
011 Rate 1/2/3 judgment H/L
012
Fastening method (trq: torque method, ang: angle method, offset: offset check)
013
Number of fastening steps
014
Self-Check Flag (SC)
ON
：
Check Performed OFF
：
Check Not Performed
015
Reverse Flag (RV)
ON
：
Reversed OFF
：
Not reversed
016
Servo lock flag (SL)
ON: servo lock performed OFF: servo lock not performed
Nm
017
1
st
Peak Torque tq Nm
018
2
nd
Peak Torque tq Nm
019
SNUG Torque Judgment tq H
020
Final Torque (Offset Torque) tq H/L Nm
021
Rate 1 Incremental Torque Nm
022 Rate 1 Incremental Angle deg
023 Rate 2 Incremental Torque Nm
024 Rate 2 Incremental Angle deg
025
Rate 3 Incremental Torque Nm
026
Rate 3 Incremental Angle deg
027
Peak Current during fastening H/L (Current High/Low Limit Warning Display) A
028 Rundown Revolutions H/L Rev.
029 Load Factor %
030 Current (Amp) Value at the time when fastening is completed A
031
Operation Sequence Number “—“ in the case of Single System or SLAVE
controller
032 Axis cycle count (×1 million) * “--" if less than 1 million cycles
033 Axis cycle count (×1)
034 Tool cycle count (×1 million) * “--" if less than 1 million cycles
035
Tool cycle count (×1)