FEC AFC3000, Руководство по эксплуатации оборудования

Страница: 247 / 294

Chapter 8 System Operation
PAGE 8- 40
D-No.003 Judgment Item 1 Standard Setting
：
111101
Set the type of judgment for fastening.
00000 1
：
Peak Torque Check
・
Performs judgment if Peak Torque during fastening is within the High / Low limits.
0000 1 0
：
Final Torque Check
・
Performs judgment if Final Torque at the end of fastening is within the High / Low limits.
000 1 00
：
Final Angle Check
・
Performs judgment if Final Angle during fastening is within the High / Low limits.
The start point of angle measurement is D-No.107 [SNUG Torque].
00 1 000
：
1
st
Rate Check
・
Judges whether the slope of the torque rise between D-No.112 [1
st
Rate Start Torque]
～
D-No.113
[1
st
Rate End Torque] is within high/low limits.
0 1 0000
：
2
nd
Rate Check
・
Judges whether the slope of the torque rise between D-No.114 [2
nd
Rate Start Torque]
～
D-No.115
[2
nd
Rate End Torque] is within high/low limits.
1 00000
：
3
rd
Rate Check
・
Judges whether the slope of the torque rise between D-No.116 [3
rd
Rate Start Torque]
～
D-No.117
[3
rd
Rate End Torque] is within high/low limits.
D-No.004 Judgment Item 2 Standard Setting
：
000001
Set the type of judgment for fastening.
00000 1
：
Timeout Check
・
Judges whether the fastening time from fastening start to D-No.105 [1
st
Torque] or D-No.205 [1
st
Angle] OR from D-No.105 [1
st
Torque] or D-No.205 [1
st
Angle] to fastening end is within the Time (1st /
2
nd
) High / Low limits.
0000 1 0
：
Revolutions Check
・
Performs judgment if the revolutions during fastening is within the Rundown Revolutions High / Low
limits..
000 1 00
：
Differential Angle Check
・
Judges whether the DIFF Angle which is calculated by 2
nd
Rate and the final torque during
D-No.114 [2
nd
Rate Start Torque]
～
D-No.115[2
nd
Rate End Torque] is within high/low limits.
00 1 000
：
SNUG Torque Check
・
Judges whether the torque value when D-No.107 [SNUG Torque] is detected does not exceed the
Snug Torque high limit.
0 1 0000
：
Break Away Torque Check
・
Judges whether the peak reverse torque value during a reverse operation does not exceed the
Reverse Torque high limit.
1 00000
：
Torque Inhibit Check
・
Checks whether the torque value during the fastening operation at D-No.205[Torque Inhibit Angle] does
not exceed the Torque Inhibit high limit.
WARNING: Fastening judgment is NOT performed regardless of the values of
the high / low limit set values when the settings of the fastening parameters
D-No. 003 “Judge Item 1” and D-No. 004 “Judde Item 2” are DISABLED (0).
Cannot be disabled
Cannot be disabled
Cannot be disabled
Caution