FEC AFC3000, Руководство по эксплуатации оборудования

Страница: 230 / 294

Chapter 8 System Operation
PAGE 8- 23
8-5-2 Single System
→
Multi System
1. Operate the arrow switches to make “System Indication,” with “SYS” indicated in the PAR No. display
and “003” indicated in the D-No. display. (In case of single system, “Single” is indicated on upper area of
the display (DATA))
2. Change the RUN/BYPASS switch of the Controller to the BYPASS position and then press the [SET]
pushbutton.
3. After transition to the set value editing mode, use the [
▲
] or [
▼
] pushbuttons to change to “Multi.”
4. After pressing the [SET] bushbutton, use the [
▲
] or [ ▼ ] pusbuttons to change the indication from “NO”
to “YES” within 2 seconds, and then press the [SET] pushbutton again.
5. Switch the RUN/BYPASS switch of the Controller to the RUN position.
6. Turn OFF the control power to the Controller.
7. By turning on the control power 10 seconds later, changing to the Multi System is accomplished.
8. To confirm the change to the Multi System, confirm that “Multi” is indicated at the upper part of the
display in “System Display,” with “SYS” indicated in the PAR No. display and “003” indicated in the D-No.
display, in the System Parameter Display Mode.
････
Depending on the Master/Slave setting, a MASTER may have to be set when changing to
MULTI mode. The display must be removed and the setting of the SW1 switch on the
Controller front panel must be changed to change the system. Please refer to “Special
Function Switch SW1 Settings” in Section 4-12-2
8
5
3
4
1
Change of
System
Parameter
◎
(SET)
2
[▲]
or
[▼]