FBII OMNI-400 EU, Инструкция по установке и настройке

Страница: 76 / 96

OMNI-400/OMNI-400EU and OMNI-600/OMNI-600EU Installation and Setup Guide
6-40
L3: Enter the cross-zone time for group 1. N/U N/U
L4: Enter the cross-zone time for group 2.
L1 L2 L3 L4
not used Group 1 Group 2
L3/L4
Entry Cross Zone Time
(secs.)
L3/L4
Entry Cross Zone Time
(secs.)
0 15 8 135
1 30 9 150
2 45 A 165
3 60 B 180
4 75 C 195
5 90 D 210
6 105 E 225
7 120 F 240
Programming Submode 3: Not used
Programming Submode 4: DESCRIPTOR PROGRAMMING
Press [
✱
] + [BYPASS] while in Installer Mode 1, then press [4] to enter Descriptor Programming
submode.
To create a descriptor:
1. Press [
✱
], then the question number representing the zone number desired.
2. Press the [INSTANT] key to move the cursor to the desired location within that question.
3. Press one of the character display keys (see table below) to display the character set.
4. When the desired character appears, press [INSTANT]. The character is accepted and the cursor
moves to the next location. To move to a previous location to change a character, if needed, press
[CODE].
5. When the descriptor is complete, accept the entry by pressing [
✱
], then the next question number.
Refer to the following chart when entering descriptors:
Key Function
[INSTANT] Accepts displayed character and moves cursor forward one position.
[CODE] Moves cursor backward one position.
[7] Displays next character in character set.
[9] Displays previous character in character set.
[#] + [7] Automatically scrolls character set display forward. Entry of [#] + [7] while
scrolling stops the scrolling.
[#] + [9] Automatically scrolls character set display backward. Entry of [#] + [9] while
scrolling stops the scrolling.
[8] Stops auto scrolling.
[0] Inserts a blank character and moves cursor forward one position.