FBII OMNI-400 EU, Инструкция по установке и настройке

Страница: 58 / 96

OMNI-400/OMNI-400EU and OMNI-600/OMNI-600EU Installation and Setup Guide
6-22
Q 12, L2
— Enter the L2 digit from the table below.
L2
Entry
Threshold
Sounder
Threshold
Bell
CS Test
Ringback
Invert Bell
Output
0
1 ✔
2 ✔
3 ✔ ✔
4 ✔
5
✔ ✔
6 ✔ ✔
7 ✔ ✔ ✔
8 ✔
9 ✔ ✔
A ✔ ✔
B
✔ ✔ ✔
C ✔ ✔
D ✔ ✔ ✔
E ✔ ✔ ✔
F ✔ ✔ ✔ ✔
Threshold Sounder: Alerts the user to the end
of exit time by sounding 4 rapid beeps 30, 20, 10,
and 5 seconds before exit time expires. When exit
time expires, the keypad will sound an
acknowledgement tone.
Threshold Bell: Similar to Threshold Sounder
option, except the alarm sounder will sound 1
second at 30, 20, 10, and 5 seconds before the
end of exit time.
CS Test Ringback: If selected, keypads will
beep after the central station has received the
system test code.
Inverted Bell Output: If selected, the alarm
sounder output signal is inverted. This is useful
when using self-actuating alarm sounders.
NOTE: If Inverted Bell Output is selected, Bell
Supervision (Submode 1, Question 09, Location
3) must be disabled.
Q 12, L3
— Enter the L3 digit from the table below.
L3
Entry
Phone Fail
Enable
Phone Fail
Sounder
Phone
Fail Bell
Bell Ring
Cancel
0
1 ✔
2 ✔
3 ✔ ✔
4 ✔
5 ✔ ✔
6
✔ ✔
7
✔ ✔ ✔
8 ✔
9 ✔ ✔
A ✔ ✔
B ✔ ✔ ✔
C ✔ ✔
D
✔ ✔ ✔
E ✔ ✔ ✔
F ✔ ✔ ✔ ✔
Phone Fail Enable: If selected, the phone line
is monitored. If a phone line is not detected for
approximately 4 minutes, a phone fail message
will be displayed; and, if the phone fail sounder
(L2) and/or phone fail bell options (L3) are
enabled, a sound will occur. The phone fail is
automatically cleared approximately 4 minutes
after the phone line has been restored.
Bell Ring Cancel: If selected, the alarm
sounder will ding upon receiving the “cancel”
code.