FBII OMNI-400 EU, Инструкция по установке и настройке

Страница: 45 / 96

Section 6. System Programming
6-9
3. Once the standard connection is made, the necessary remote communications sessions can take
place (upload, download, remote commands).
4. The installer hangs up the telephone or removes the headset from the line to prevent interference
that may affect upload/download data. The downloader software will automatically terminate the
connection after remote communications end.
Data Entry via Keypads
This section describes the physical keystrokes necessary to perform keypad programming and explains
how to interpret the data displayed on the LED-based keypads and on the LCD keypads during
programming operations.
NOTE: Actual keypad programming should be performed only after completion of the programming
sheet.
How to Enter Programming Mode
The SYSTEM programming mode can be entered WHILE DISARMED ONLY as follows:
TO ENTER INSTALLER PROGRAMMING: Press [CODE] + [
✱
] + Installer Code + [1], then
select programming Submode 1, 2, or 4 from the prompt (shown below).
1 = System 2 = Zones
4 = Descr
Where:
[CODE] = CODE button
[
✱
] = Star (
✱
) button
Installer Code = 4- or 6-digit† Installer Code (default = 2468)
[1] = [1] button. This indicates Installer Mode 1.
† User/installer codes can be 4 or 6 digits, as set in Question 09, L3.
Installer Mode 1 Submodes:
1 = System Options
2 = Zone and All Central Station Report Code Programming
3 = Not Used
4 = Zone Descriptor Programming
What You See on the LCD Keypad
Upon entering the installer keypad programming mode, LCD keypads
display:
Q#: 01 M1 Edit L:01
DATA: 1234 System
The display shows:
Q# = the current question number
M1 = the submode number
L: = the location within the question
DATA: = the current value within that location
System: = the submode title