FBII OMNI-400 EU, Инструкция по установке и настройке

Страница: 48 / 96

OMNI-400/OMNI-400EU and OMNI-600/OMNI-600EU Installation and Setup Guide
6-12
REPORTING ROUTE:
The system can report to 1 or 2 central station phone numbers. If you select split reporting, then
OPENING and CLOSING signals will be directed to the secondary phone number, while all other
signals will be transmitted to the primary phone number. If you select backup reporting, the panel will
alternate between the primary and secondary receivers (if the second phone number is programmed)
for a programmable number of attempts (Question 08, L3) to each phone number in the event the
signal has not been acknowledged. If you select dual reporting, then signals will be sent to both
primary and secondary phone numbers. If neither split nor backup reporting is necessary, then this
question may be left as factory-defaulted, and all conditions will be routed to the primary number only.
Enter the telephone number (including area code or dialing prefix, IF NECESSARY) of the secondary
central station receiver in Question 02, L1–L20.
Q 01 PRIMARY TELEPHONE NUMBER
Q 02 SECONDARY TELEPHONE NUMBER
Q 03 CALLBACK TELEPHONE NUMBER
Enter the telephone number (including area code or dialing prefix, if necessary) for this control panel to
reach the callback number location. The callback number is the optional location of the Downloading
Software where the control panel will call during a remote communications (upload/download etc.)
session. During remote communications, the programming device and the control panel will first
confirm the CS security code. If valid, communications can begin. If a callback number is defined, the
control panel will hang up and dial the callback number. For no callback capability, enter “A” in L1
–
L20.
Q 04 PAGER TELEPHONE NUMBER
Enter the pager number for reports, up to 16 digits (including area code or dialing prefix, if necessary).
For no pager report, enter “A” in L1
– L16.
QUESTIONS 05–06 ACCOUNT NUMBERS
Primary account: Enter the 3- or 4-digit subscriber account number for central station phone number
1 in Question 05, Locations L1
– L4. If a 3-digit number is used, then enter an “A” in location L4. Valid
entries are 0
–
9, and B
–
F. The value “A” is interpreted as the null value for account numbers.
Secondary account: Enter the 3- or 4-digit subscriber account number for central station phone
number 2 in Question 06, Locations L1
– L4. If the second phone number is not used, this question can
be left as factory-defaulted.