FBII OMNI-400 EU, Инструкция по установке и настройке

Страница: 44 / 96

OMNI-400/OMNI-400EU and OMNI-600/OMNI-600EU Installation and Setup Guide
6-8
1. The PC operator must select UNATTENDED DOWNLOAD in the Downloader Software Main
Menu.
2. Enter unattended download mode: [CODE] + [
✱
] + Installer Code + [8].
3. The system will now enter keypad programming, Question 01. Enter the telephone number of the
central station downloading computer (each digit followed by the [#] key; e.g., [1] [#] [2] [#] [3] [#]
etc.) into this question (20 digits maximum). This phone number should be the same as the CS
callback number (Question 03 from keypad programming if the panel is programmed for callback).
4. Press the [INSTANT] key to proceed to Question 02. Next, enter the desired unattended
identification number (each digit followed by the [#] key). This will be used by the Compass software
in the CS downloading computer to determine the proper account information to download to this
subscriber. The account number must be 12 digits in length. It is the unattended identification
number (not the account number) that will be communicated to the Compass software in the CS
downloading computer. For account numbers fewer than 12 digits, you must enter leading 0's to
make the number 12 digits long.
Example: for account number 345, enter 0 # 0 # 0 # 0 # 0 # 0 # 0 # 0 # 0 # 3 # 4 # 5 #
5. Press the [STAY] key to exit programming mode. The control panel will now dial the telephone
number entered into the callback number. The downloading computer must be placed into the
Unattended Communications option from the main menu. Upon connection with the computer, the
system will obtain the customer account number programmed in step 3 and perform the desired
download operation.
NOTE: The CS downloading computer must be waiting in the Unattended Communications mode and
preprogrammed with the account information in order for the unattended download to be functional.
UL
The unattended download mode CANNOT be used in UL installations.
INSTALLER MODE 9 (ON-LINE DOWNLOAD)
In this mode, the installer can initiate a remote communications session with the CS Downloading
computer at the control panel location. Typically, the CS initiates a remote communications session.
On-line Downloading allows the installer to call the office (from the same telephone line as the panel),
discuss the action required, and allow the CS operator to complete the request while on-line; no
additional telephone call is needed. Note that the office number that is dialed should be the phone line
that the downloading computer is attached to. On-line connection can be made as follows:
1. Installer completes installation and attaches a handset to telco terminals (tip & ring) or uses the
standard home telephone to dial the CS Downloading modem telephone line. Connection is made
with a person at the CS Downloading computer and the account to be downloaded is verbally
identified. The downloading computer operator then selects the On-line Remote Operations from the
device menu.
2. The installer enters the on-line download sequence: [CODE] + [
✱
] + Installer Code + [9] or uses the
end-user command of # 9, if enabled (Question 10, L1). This will cause the control panel to react as
if it received a request for a remote communications session, and to look for the standard panel-to-
CS protocol.