Fagor 8055i FL EN, Руководство по эксплуатации

Страница: 80 / 160

·80·
Operating manual
CNC 8055
CNC 8055i
3.
WORKING
WITH OPERATIONS OR
CYCLES
·MC· O
PTION
S
OFT
: V02.2
X
Profile
mil
ling
o
peratio
n
3.3.1 Definition of data
Coordinates of the first and last points.
The coordinates are defined one by one. After placing the cursor on the coordinates of the axes to
be defined, the value is entered in one of the following ways.
• Entering the value manually. Key in the desired value and press [ENTER].
• Assign the current machine position.
Jog the axis with the handwheel or the JOG keys up to the desired point. Press [RECALL] so
the selected data assumes the value shown in the top right window and press [ENTER].
The top right window shows the tool position at all times.
Intermediate points (level 1).
The intermediate points are defined one by one. When not using the 12 definition points, the first
unused point must be defined with the same coordinates as the last point of the profile.
The following must be defined for each point.
If a coordinate is left blank, the cycle will assume that it is the same as that of the previous one.
The coordinates of each point may also be defined incrementally. To do that, select the desired
coordinate with the cursor and press the two-color key. Both coordinates of the selected point will
be shown preceded by the "

" icon that indicates the incremental value with respect to the previous
point.
Deleting all the points of a profile.
Once all the desired points have been programmed, they may all be erased at once. To delete all
the programmed points at the same time, proceed as follows:
• Place the cursor on the text "DEF. PROFILE (max 12 points)" of the window where the points
are edited.
• In the instant the cursor is placed in this position, the text changes to: "CLEAR - Delete all the
points".
• At this moment, pressing [CLEAR] displays a window requesting confirmation to delete all the
points: Press the [ENTER] to delete all the points or [ESC] not to delete them.
• The X, Y coordinates are defined one by one like the coordinates of the first and last
points.
• Type of corner. To select the type of corner, place the cursor over this icon and press
the two-color key.
If defined... The CNC assumes...
X1 25.323 Y1 26.557 Point: X1 25.323 Y1 26.557
X2 Y2 78.998 Point: X2 25.323 Y2 78.998
X3 67.441 Y3 83.231 Point: X3 67.441 Y3 83.231
X4 Y4 Point: X4 67.441 Y4 83.231
X5 Y5 There are no more points, it is a repetition of the previous
point.