Fagor 8055i FL EN, Руководство по эксплуатации

Страница: 145 / 160

Operating manual
CNC 8055
CNC 8055i
SAVING PROGRAMS
5.
·MC· O
PTION
S
OFT
: V02.2
X
·145·
Modify a
part-program
5.7.4 Modify an existing operation
To modify an operation, proceed as follows:
1. Select, with the pointer, the block or cycle to be modified from the right column.
2. Press the [RECALL] key.
The CNC will show the editing page for that operation.
3. Modify all the desired data.
To save the modified operation, proceed as follows:
1. Press [P.PROG] to access the list of part-programs stored.
The CNC shows the pointer on the same operation. To select another position, use the [

][

]
keys; the new operation will be inserted after the selected one.
2. Press the [ENTER] key.
To place the modified operation in its previous location, the CNC will show a message asking to either
replace the previous operation or keep it inserting the new one after it.
The following example modifies the "rectangular pocket" operation.
Current program Option "Replace" Option "Insert"
1.- Rectangular pocket 1.- Rectangular pocket 1.- Rectangular pocket
2.- Circular pocket 2.- Circular pocket 2.- Rectangular pocket
3.- Circular pocket
It is possible to select an existing operation, modify it and then insert it in another position and even
in another part-program.
i