Fagor 8055i FL EN, Руководство по эксплуатации

Страница: 131 / 160

Operating manual
CNC 8055
CNC 8055i
OP
ERAT
ING IN
IS
O MODE
4.
·MC· O
PTION
S
OFT
: V02.2
X
·131·
P
rogramming assistance
4.2.7 Plane change
An icon may be used to select the plane (G16, G17, G18 or G19)
where the canned cycle will be executed. This way, the cycles may
be executed in any of the three planes.
When selecting G17, G18 or G19, the three boxes are automatically
filled in with the names of the corresponding axes. Also, the main
view highlights the selected plane.
When selecting G16, the user can write the names of the axes in
the boxes as he wishes. In this case, the main drawing does not
highlight any plane.
If there are only XYZ axes, the selection icon does not show the
option for free configuration (G16).
If a block is programmed with a change of plane; from then on, all
the milling cycles may be executed in the new plane.
When turning the CNC off and back on, it loses the plane it was
working with and the work plane is the one indicated by machine
parameter IPLANE (XY or ZX).
Icon that serves to indicate the plane active in the cycle when the selected plane does
not correspond with the plane indicated by general machine parameter IPLANE
(P11). This icon will only be shown before pressing [START], after pressing [ESC].