Fagor 8055i FL EN, Руководство по эксплуатации

Страница: 154 / 160

·154·
Operating manual
CNC 8055
CNC 8055i
6.
EXECUTION AND SIMULATION
·MC· O
PTION
S
OFT
: V02.2
X
Graphi
c rep
resentatio
n
6.5 Graphic representation
The operating manual, M model, "Graphics" section of the "Execution / Simulation" chapter
describes how to use the graphics display. However, here is a brief description of the softkeys.
Type of graphic
Display area
With this option it is possible to re-define the display area by defining the maximum and minimum
values for each axis.
Use the [

][

] keys to select the maximum and minimum values. Once all the data has been defined,
press [ENTER].
When selecting a new display area, the CNC clears the screen and shows the axes or the part
unmachined.
Zoom
With this option, it is possible to enlarge or reduce the graphics display area.
It shows a window superimposed on the current graphics and another one over the drawing at the
lower right-hand side of the screen. These new windows indicate the new display area being
selected.
Use the [

][

][

][

] keys to move the window around, the softkeys "ZOOM+" "ZOOM-" to enlarge
or shrink its size and press [ENTER] for those new values to be assumed.
When the [GRAPHICS] key is pressed, the CNC displays the graphic representation
page of the M model. To leave the graphic representation mode, press the [GRAPHICS]
key or the [ESC] key.
During simulation, the top center window shows the number of the program and the
number of the cycle being executed. However, when detecting an RPT or GOTO
instruction, the cycle number will disappear.
3D It draws the part in three dimensions.
XY, XZ, YZ They draw the part in the selected plane.
C O M B I N E D
VIEW It divides the screen in four quadrants and draws the graph corresponding to each
plane XY, XZ, YZ and the three-dimensional graph.
TOP VIEW It draws a top view (XY plane) with different shades of gray that indicate the depth
of the part.
It also displays the XZ and YZ sections for the areas shown by the indicators of
the top view (XY plane).
SOLID It shows a three-dimensional block that will be "machined" as the part-program
is being run.
The display area cannot be changed while executing or simulating the part. If it is,
interrupt the execution or simulation by pressing the [STOP] key.