Fagor 8055i FL EN, Руководство по эксплуатации

Страница: 66 / 160

·66·
Operating manual
CNC 8055
CNC 8055i
2.
O
PERATING
IN JO
G MODE
·MC· O
PTION
S
OFT
: V02.2
X
Tool
cal
ibratio
n
Programming method for probe coordinates
It indicates whether the cycle assumes the probe position defined in the machine parameters or the
position defined in the cycle. To select one of them, use the cursor to select the "Machine parameters
/ Programmable parameters" box and press the two-color key.
Machine parameters: The cycle assumes the probe position defined in the machine
parameters.
Programmed parameters: The cycle assumes the probe position defined in the cycle (Xmax,
Xmin, Ymax, Ymin, Zmax, Zmin).
[ Xmax ] Approximate X axis coordinate of the most positive side of the probe
Approximate coordinate of the most positive side of the probe, along the abscissa axis. If not
programmed, it will assume the value of general machine parameter PRBXMAX (P41).
[ Xmin ] Approximate X axis coordinate of the least positive side of the probe
Approximate coordinate of the least positive side of the probe, along the abscissa axis. If not
programmed, it will assume the value of general machine parameter PRBXMIN (P40).
[ Ymax ] Approximate Y axis coordinate of the most positive side of the probe
Approximate coordinate of the most positive side of the probe, along the ordinate axis. If not
programmed, it will assume the value of general machine parameter PRBYMAX (P43).
[ Ymin ] Approximate Y axis coordinate of the least positive side of the probe
Approximate coordinate of the least positive side of the probe, along the ordinate axis. If not
programmed, it will assume the value of general machine parameter PRBYMIN (P42).
[ Zmax ] Approximate Z axis coordinate of the most positive side of the probe
Approximate coordinate of the most positive side of the probe, along the Z axis. If not programmed,
it will assume the value of general machine parameter PRBZMAX (P45).
[ Zmin ] Approximate Z axis coordinate of the least positive side of the probe
Approximate coordinate of the least positive side of the probe, along the Z axis. If not programmed,
it will assume the value of general machine parameter PRBZMIN (P44).
Arithmetic parameters modified by the cycle
Once the cycle has been completed, the CNC will return the real values obtained after
measurement, in the following global arithmetic parameters.
P295 Real coordinate of the least positive side of the probe, along the abscissa axis.
P296 Real coordinate of the most positive side of the probe, along the abscissa axis.
P297 Real coordinate of the least positive side of the probe, along the ordinate axis.
P298 Real coordinate of the most positive side of the probe, along the ordinate axis.
P299 Real coordinate of the measured probe side along the longitudinal axis.