Fagor 8055i FL EN, Руководство по эксплуатации

Страница: 138 / 160

·138·
Operating manual
CNC 8055
CNC 8055i
5.
SAVING PROGRAMS
·MC· O
PTION
S
OFT
: V02.2
X
Savin
g
an ISO block or a cycl
e
5.4 Saving an ISO block or a cycle
The block or cycle may be added at the end of the program, after the last operation or insert it between
2 existing operations.
To save the block or cycle, proceed as follows:
1. Define the desired block or cycle assigning the relevant data to it.
2. Press [P.PROG] to access the list of part-programs stored.
3. Select, with the pointer, the desired program number on the left column and switch over to the
right column.
4. Place the pointer on the operation after which the block or cycle is to be saved and press
[ENTER].
Example:
To insert the "Drilling 1 + linear positioning" operation, once the operation has been defined, place
the pointer on the "Circular pocket" operation and press [ENTER].
To insert the "Profile 1" operation, once the operation has been defined, place the pointer on the
last operation "Thr Grid pattern positioning" operation and press [ENTER].
Current program Desired program
Bidirectional surface milling in X Bidirectional surface milling in X
Rectangular pocket Rectangular pocket
Circular pocket Circular pocket
Drilling 1 + linear positioning
Drilling 1 + grid pattern positioning Drilling 1 + grid pattern positioning
Thr Grid pattern positioning Thr Grid pattern positioning
Profile 1