Fagor 8055i FL EN, Руководство по эксплуатации

Страница: 58 / 160

·58·
Operating manual
CNC 8055
CNC 8055i
2.
O
PERATING
IN JO
G MODE
·MC· O
PTION
S
OFT
: V02.2
X
Tool
cal
ibratio
n
Tool calibration
The right window shows the tool dimensions and the lower left window shows the necessary data
to calibrate it.
To access the calibration window, (lower left window) and, thus calibrate the tool, the tool must be
selected on the machine. If it is not, press the [T] key, key in the desired number of the tool to be
calibrated and press [START].
Select the lower left window with the [

] [

] [

] [

] keys Enter the Z coordinate of the part to be
used in the calibration and press [ENTER].
Tool calibration (only measuring the length).
1. Approach the tool to the part and touch it with it.
2. Then, press the keystroke sequence [Z] [ENTER].
The tool has been calibrated. The CNC assigns the corresponding length (L) to it and resets the
K offset value to 0. The tool radius (R) must be entered manually.
To calibrate another tool:
1. Select it on the machine.
2. Approach the tool to the part and touch it with it.
3. Then, press the keystroke sequence [Z] [ENTER].
Modifying the tool data while executing a program
It is possible to modifying the tool values (dimensions and geometry) without interrupting the
execution of a program.
To exit this screen, press [ESC].
To do that, press the tool calibration key. The CNC will show the tool calibration screen
with all the data for the active tool and it will allow modifying its data or of any other tool.