Fagor 8055i FL EN, Руководство по эксплуатации

Страница: 64 / 160

·64·
Operating manual
CNC 8055
CNC 8055i
2.
O
PERATING
IN JO
G MODE
·MC· O
PTION
S
OFT
: V02.2
X
Tool
cal
ibratio
n
Operation
After selecting the type of part to be centered (rectangular or circular) proceed as follows:
1. Move the tool until touching the desired point of the part.
2. Place the focus in the box of the type "1 - RECALL" corresponding to the desired point and press
[RECALL]. At this time, the coordinates of that point will be updated.
3. Repeat steps 1 and 2 for the rest of the points of the part.
4. After updating all the points, to calculate the center and the angle, place the focus on the
"CALCULATE" button and press [ENTER]. The angle is only calculated when the part is
rectangular and centering is done on both axes.
5. Once the whole process is finished, the CNC screen will show the center of the part and the
angle if it has been selected.
If coordinate preset is active and the new part zero changes, the CNC will request confirmation.
6. If the new coordinate preset has been applied and it is working in part coordinates, the
coordinates of the points will be updated with respect to the new reference point.
Arithmetic parameters modified by the cycle:
Once the part center and angle (only if necessary) have been calculated, the values obtained will
be saved in the following general arithmetic parameters:
P296 Angle between the part and the X axis (

).
P298 Part center along the X axis (Xc).
P299 Part center along the Y axis (Yc).
In the ISO mode of the conversational mode, on the screen of the programming assistance for
pattern rotation, when pressing [RECALL] while the focus is in the

field, this parameter will take
the value calculated in the manual part centering cycle.
If the last cycle executed at the CNC using global parameter P296 was not the manual centering cycle,
the

value will not be the one calculated in this cycle.