EXFO FTB-860, Руководство пользователя, Страница: 103 / 409

RFC 2544 Test Setup and Results
NetBlazer
91
Summary Results

RX Frames : The count of received frames for the iteration in progress
after the test frames have been transmitted and a pause of 2 seconds
has passed. This value is kept throughout the iteration until the next
iteration begins. When the next iteration starts, the value displayed will
momentarily be “
0 ” while data is collected.
Note:
While a subtest is in progress, the status and results are displayed on the
page in real time, and are retained under the results table for each subtest.
Throughput

Results In : The throughput value is expressed in Mbit/s by default. The
default is
Gbit/s
for 10G interface. The user can also specify the values
to be displayed as a percentage ( % ) of the line rate or in Frames per
Second (
frame/s
), and
Gbit/s
for 10G interface.

Layer : Select the layer for determining the throughput results layer to
display. The default setting is
All
. Choices are:
Note: The Throughput results expressed in frame per second ( Frame/s ) always
considers all layers.
All : Considers all layers to display the Throughput results and
represents the Ethernet line utilization.
Ethernet : Displays the T hroughput results calculated at the Ethernet
layer. While calculating the line utilization, the IFGmin and the
Preamble/SFD are not considered.
IP
: Displays the
Throughput
results calculated at the IP layer. While
calculating the utilization of the Ethernet frame size, FCS and VLAN
header (if any) are removed from the frame size to consider only the
third layer.
The
Throughput
results displayed on the bottom half of the page are
displayed for the selected frame size distribution.