Estun pronet series, Руководство пользователя

Страница: 104 / 193

ProNet Series AC Servo User's Manual
- 102 -
4.6.6 Positioning Completion Output Signal
This signal indicates that servomotor movement has been completed during position control. Use the signal as an
interlock to confirm that positioning has been completed at the host controller.
Type Signal Name Connector Pin Number Setting Meaning
Output /COIN
CN1-11,CN1-12
(Factory setting)
ON (low level) Positioning has been
completed.
OFF (high level) Positioning is not
completed.
· This output signal can be allocated to an output terminal with parameter Pn511. Refer to 3.2.2 I/O Signal Names and
Functions
.
· The factory setting is allocated to CN1-11,12.
Pn500
Positioning Error
Setting Range Setting Unit Factory Setting Setting Validation
0 ～ 5000 1Puls 10 Immediately
Pn520
Position complete time
Setting Range Setting Unit Factory Setting Setting Validation
0~60000 0.1ms 500
Immediately
·
The positioning completion (/COIN) signal is output when the difference (position error pulse) between the number of
reference pulses output by the host controller and the travel distance of the servomotor is less than the value set in this
parameter and the stabilization time is more than the value of Pn520.
·
Set the number of error pulses in reference unit (the number of input pulses defined using the electronic gear).
·
Too large a value at this parameter may output only a small error during low-speed operation that will cause the /COIN
signal to be output continuously.
·
The positioning error setting has no effect on final positioning accuracy.
Reference
Servomotor speed
Pn500
Speed
Error pulse
(Un011,Un012)
/COIN
(CN1-11,12)
■ Note
· /COIN is a position control signal.
· This signal is used for the speed coincidence output /V-CMP for speed control, and it always OFF (high level) for torque
control.
Position
Position