63
EN
Firmware update
The update function allows you to update the firmware of the control panel and/or of the connect-
ed modules. For an update you will need an empty mass storage device with the standard type A
connector.
•
Download the firmware from www.eos-sauna.de/service-support/software and unzip the ZIP
file to your mass storage device.
•
Plug in the mass storage device to the connector on the rear side of the control panel (control
panel has to be removed from the bottom housing).
•
Open the service level settings and touch twice the
„Update“ symbol:
•
You will see thee possible options for the update:
- Control panel
- Relay box only (currently selected cabin)
- Coloured light module (if connect-
ed, currently selected cabin only)
•
Select the required option and und touch it briefly
again, to launch the update.
•
The update process will be started and will be dis-
played on the screen with the appropriate progress
bars. The update may take several minutes. After the update the unit will reboot.
•
If not firmware files are found an error message will be shown. Check the mass storage device
and repeat the update.
•
Upon the update you can remove the mass storage device (hot plugging supported).
HINT:
You can also launch the update menu directly with the short-cut access code. Touch the
settings symbol
for 5-6 sec until the pin code prompt appears and give in the access code
543210
. The update menu will be launched directly.
!
Notice
: Make sure that the power supply is not interrupted during the update process.
Otherwise the files may get corrupt and the control unit will need to be sent to the manu-
facturer.
!
Attention
: The update may be carried out only by an appropriately skilled person.
In the case of power supply loss the control panel will attempt to resume the update process. If the
display panel does not start or shows a boot load error press firmly on the “reset” button on the
board next to the battery cell. The unit will reboot and offer update options dialogue, allowing you
to attempt to repeat the update.
mass storage
connector
