26
EN
SENSOR
SENSOR
SENSOR
SENSOR
JP1
S-BUS
15. Oktober 2013
14:22:38
ca. 160 - 170 cm
30 mm
The temperature sensor should be connected to one of
the free „Sensor Bus“ ports on the main board.
The sensor is fitted with a small intermediate connector
right behind the sensor. Thanks to this connector you
can replace the standard 5 m cable with the optionally
available 20 m or 50 m cable if necessary.
Make sure to observe the installation depth - 30 mm as
shown on Pic. 12-13 must be observed. Make sure to
apply sufficient silicone around the sensor for insula-
tion and humidity protection.
Special notice
Sensor cable connects with the
RJ10 plug to the one of four „sensor
bus“ RJ10 ports. You can use any of
these ports at your choosing.
The sensor will be automatically
connected and configured.
The sensor must not be connect-
ed to the larger RJ14 “sauna bus”
port (connection of display panel
and modules). This will damage
the board and the sensor!
Pic. 12
Pic. 13
7.2 Temperature sensor - installation overview
30 mm
sensor
cable
RJ10 plug
itenmediate
connector
sensor bus jack RJ10 in
the steam generator
tiles
glue
vapour barrier
outer wall structure
wall structure
silicone insulation
