55
EN
Firmware
- displays the current firmware version of the control panel and the contactor
box or connected modules. Press arrow symbols to switch between the values. “Panel Vx.xx”
- control panel firmware, “Mod-LS Vx.xx” - contactor box firmware (x is any number). By con-
nected extension modules their firmware version will be also displayed.
Service intervals
- display the hours left until the next regular maintenance (service) is
due. Your dealer or installer sets the intervals during installation and setup.
Contact details
Displays the manufacturer’s contact details. These details are also displayed if a fault occurs.
Display brightness
Here you can adjust the display brightness. Use the slider bar (pull up or down) to set the bright-
ness to you preference.
Holiday home mode
This function allows to limit the user access down to only few basic functions. All other settings will
be locked and their icons hidden.
In this mode the user access is limited to the following:
•
Cabin on/off
•
Light On / Off
•
Temperature setting
Touch the
icon to enable this function. Enter your personal PIN code in the next dialogue. Use
the numerical keypad to enter a 4 - 8 digit number and confirm your entry. The unit will be locked.
To unlock the unit, go to the settings menu again. Touch the
icon twice. A PIN code prompt
screen is displayed. Enter the correct PIN code to unlock the unit. When you turn off the cabin, the
language selection dialogue is displayed.
After the operation a selection of operation languages will appear before the new start. To leave
this menu touch briefly on the “back” arrow.
!
ATTENTION
Make sure to remember the selected pin code! Please bear in mind that in the case this
code is lost you
will not
be able to operate the control unit. In the case the pin code is
no longer available and cannot be restored please contact your local EOS dealer or EOS
service.
