24
EN
Display panel installation
Place the control panel directly in front of the housing base and pay attention to the correct orien-
tation - the cable connector shall be at the bottom and the SD card slot / mass storage connector
at the top. The display panel should be connected to the relay box / steam generator as described
on the page 22-23.
Now carefully press the control panel into the housing base until you hear a click sound (hooks of
the upper part should snap into the holders in the base). Make sure the control panel sits reliably
in the base part. Pay attention to the correct cable position inside bottom housing.
Installation hint: When you lay the connection cable allow some extra length around the base, so
that later you can take the control panel out of the base easily.
Pic. 9
Taking the display panel out
To remove (detach) the control panel use the included de-installation
tools or two slotted screwdrivers. Insert the tools or screwdrivers into the
grooves located on the bottom side (between housing upper part and
housing base) and carefully pull it away from the wall until control panel
is released from the base and may be taken out. Do not apply excessive
force as this may damage the inner holders.
Take the control panel out of the base. Disconnect the connection cable
by pressing on the securing clip and unplugging the cable. After that you can completely remove
the display panel from the bottom housing.
Attention! Be careful not to damage the front glass by removing the display out of the bottom
hosing. The removal tools should not be applied so that they lean on glass or the display panel
is twisted. Do not pull the display panel by holding the glass!
Outer wall of
the cabin
Insulation
Connection cable
Cabin inner
wall
Pic. 10
