41
EN
Multi-cabin connection and configuration
The EmoTouch 3 control unit allows to control up to 8 separate cabins from one display panel.
These can be saunas, steam rooms or hammams. The connection is made to the 4 connectors
(ports) on the rear side of the display panel (see picture below).
Please observe, that for each port connection a special ferrite ring should be added to the con-
nection cable. For installation details please refer to the page 20, illustration 7.
For every additional cabin a ferrite ring will be included along with the connection cable with the
corresponding extension module (relay box).
Connection for multi-cabin control
Independently to if the Emotouch 3 is intended for sauna, steam room or hammam control the
connection of one or several cabins always effects basing on the following standard scheme:
1. Cabin
The relay box of the 1
st
cabin connects with the
sauna bus
cable
to the
1
st
port
of the display panel.
2. Cabin
The relay box of the 2
nd
cabin connects to the free sauna
bus connector in the relay box of the 1
st
cabin.
The relay box of the cabin #2 must be programmed to the
ID „2“ after connection.
3. Cabin
The relay box of the 3
rd
cabin connects to the
2
nd
port
of the
display panel.
The relay box of the cabin #3 must be programmed to the ID „3“ after connection.
4. Cabin
The relay box of the 4
th
cabin connects to the free sauna bus connector in the relay box of the 3
rd
cabin.
The relay box of the cabin #4 must be programmed to the ID „4“ after connection.
5. Cabin
The relay box of the 5
th
cabin connects to the
3
rd
port
of the display panel.
The relay box of the cabin #5 must be programmed to the ID „5“ after connection.
6. Cabin
The relay box of the 6
th
cabin connects to the free sauna bus connector in the relay box of the 5
th
cabin.
The relay box of the cabin #6 must be programmed to the ID „6“ after connection.
7. Cabin
The relay box of the 7
th
cabin connects to the
4
th
port
of the display panel.
The relay box of the cabin #7 must be programmed to the ID „7“ after connection.
8. Cabin
The relay box of the 8
th
cabin connects to the free sauna bus connector in the relay box of the 7
th
cabin. The relay box of the cabin #8 must be programmed to the ID „8“ after connection.
1
2
3
4
Rear side of the display panel with 4 connec-
tion ports for multi-cabin connection.
