17
EN
Pic. 2
Drill 4 mounting holes in the wall as shown on the template below. If
necessary use the appropriate dowels to securely mount the screws in
the drilled holes.
At first screw in the two upper screws. As shown on the pic. 2.
please make sure to leave 3 mm gap between the screw
head and the wall surface.
Now hang the steam generator with the
corresponding mounting holes in the chas-
sis on these two screws. Make sure that the
generator is hanging vertically (by using a
spirit level).
After that secure the generator by screw-
ing the bottom pair of screws to the wall
through the corresponding bottom mount-
ing holes in the chassis. After that also tight-
en the upper pair of screws.
Put the outer housing back on the chassis.
Lower it down so that the housing snaps at
the top into the chassis, then pull the low-
er end sides slightly apart and push them
on the lower side of the chassis. Line up the
holes in the housing with the correspond-
ing holes in the chassis. Secure the housing
with the mounting screws.
See the pic. 3 for details.
3
535
420
alle Maße in mm
all sizes in mm
Pic. 3
Important notice:
Make sure that the steam gen-
erator is mounted level and
perpendicular.
