EMBRON Hatteland X Series, Руководство пользователя

Страница: 28 / 134

28 Installation
IND100078-38
Installation Procedures
Mounting of Base to Floor (Table model)
The Chart & Planning Table requires secure mounting to floor and it is assumed that the incoming cables (for main power and
additional cables required for computer etc.) comes through the floor. All procedures should be performed by a skilled technician
that can interpret the physical parts and correctly identify them on the illustrations below for correct installation.
▼1: Review the 2 x cable openings (oval) in the bottom stand as
indicated below prior to drilling holes in floor. For measurements,
review Technical Drawings chapter in this manual.
▼2: Review the 6 x mounting points in the bottom stand as
indicated below prior to drilling mounting holes. For measurements,
review Technical Drawings chapter in this manual.
▼3: Close-up view. Holes in RED circle=ø10.50mm [0.41”].
Holes marked in RED square=ø8.50mm [0.33”].
▼4: Review next page “Access to Power Cable Input (Table Model)”
to remove Top and Bottom Covers to get access to holes on the
inside. Once covers are removed, proceed to point 5 below.
▼5: Mount the base to the floor with mounting bolts. Hatteland Technology suggests 2 x M8 (in center of base, see point 3) + 4 x M10
(each side of base, see point 3) with washer, spring washers, locking nut, Material Grade 10.9/12.9, acid-proof stainless steel, length is
dependent of floor thickness.