EMBRON Hatteland X Series, Руководство пользователя

Страница: 74 / 134

74 User Controls
OSD Menu Functions
IND100064-48
|---2---
Miscellaneous > GDC Sensitivity
The touch enabled symbols known as GDC (Glass Display Control™) can be adjusted in sensitivity.
It basically means that a small value requires a larger area to be covered longer over time, while a
large value will require less smaller area to be covered in less time. If you set the value too low or
too high, you may feel a difference in either increased responsiveness or the lack of such. By
factory default, the most optimal value has been preset.
Values from 0 to 255.
● Note: Default is model dependent and set by factory. Note that the difference between 0 and 255 is minimal,
as it is not suitable to go beyond a fair responsiveness that could cause accidental triggering of functions to
occur by nearby objects touching the glass (i.e. rain drops for instance, washing glass with cloth).
● Caution: If the sensitivity value was set very low, you may experience an increased occurrence of non-
responsiveness which also affects accessing the correct menu function in order to re-adjust this value. It is
therefore suggested as a last resort solution to reset this value via SCOM (Serial/Ethernet Communication)
functionality instead by sending a “Reset Factory Default” (or “Load User DSlot Number, if available
and previously stored by using “Save User DSlot Number) commands if you are unable to navigate
the OSD menu.
|---2---
Miscellaneous > Power Plan
This setting will allow you to control the overall power mode in Power off mode.
Settings as follows:
“Enable” = Enabled power off mode.
“Disable” = Disabled power off mode.
● Note: Factory Default set to “Disable”
|---2---
Miscellaneous > Lan/Sleep Mode
This setting will allow you to control the power mode of Ethernet port in Power off mode.
Settings as follows:
“Enable” = Enabled in power off mode.
“Disable” = Disabled in power off mode.
● Note: Factory Default set to “Enable”