EMBRON Hatteland X Series, Руководство пользователя

Страница: 36 / 134

36 Installation
IND100078-42
Maintenance Procedures
Detach the Display Unit from the Table Stand
The Chart & Planning Table (hereby referenced as Unit) is mechanically a regular Display unit mounted on-top of a Tilt and Lift
enabled Table Stand mount. In any event that you need to replace just the display unit for service purposes or due to moving the
unit physically into a space that is too narrow prior to final installation - please follow the instructions below carefully. At least three
persons should together perform this operation due to size and weight of the Display unit (approx 60kg) along with disconnecting
the Glass Display Control ™ (GDC) interface before lifting the Display unit off and away from the Table Stand mount.
Note: Illustrations below may deviate slightly from written instructions (based on how the unit was delivered/tested prior to actual
installation onboard occurs). All procedures should be performed by a skilled technician that can interpret the physical parts and
correctly identify them on the illustrations below for correct installation).
▼1: First you need to remove the Top Ceiling Panel. Notice
this panel is located just above the front mounted Main Power
Switch and USB connectors.
▼2: Remove 6 screws as indicated to remove the Top Ceiling Panel
to reveal the connectors.
▼3: Make sure that all cables are disconnected from the
Display’s signal input/output connectors before proceeding to
the next step!
▼4: Location of 4 screws to be removed. One in each corner from
underneath.
▼
5: Carefully lift the display unit up and disconnect any other cables that may still be connected (two persons lifting) and
disconnected the GDCx cable (third person). Place the Display unit down on a flat table (display facing up). Reverse the
procedure to mount the Display unit back onto the Table Stand.
GDCx Cable