EMBRON Hatteland X Series, Руководство пользователя

Страница: 25 / 134

25
IND100210-34
General Installation Recommendations
Installation
Ferrite
The ferrite prevents high frequency electrical noise (radio frequency interference) from exiting or entering the
equipment. This ferrite is required when connecting a RS-232 cable to the SCOM on the unit
(1 x 9p D-SUB, female, non-isolated) connector to be fully compliant with type approvals.
The ferrite should be mounted (clipped in place on the cable) and
located as close as possible to the connector piece that connects to
the rear of computer.
When ready: Open the ferrite, place the cable inside as shown in
FIG1, and then gently close it until a click can be heard (FIG2). You
may close and re-open them as many times as required during the
installation.
Red Line indicate where Ferrite should be mounted (as close as possible to the connector).
Do not mount ferrite ( orange square ) below the red line!
Typenumber Ferrite Type Dimetric View Preferred distance of ferrite. Side view.
HD 55T22 MVD-MAx-CORx
HD 55T22 MVD-MAx-COTx
Console Models
1 x Würth 742 711 31
HD 55T22 MVD-MAx-AOGx
Wall / Desktop Mount Model
1 x Würth 742 711 31 Red Line indicate where Ferrite should be mounted (as close as
possible to the connector). Do not mount ferrite ( orange square )
outside the red line!
FIG1
To computer
FIG2
To computer