EMBRON Hatteland X Series, Руководство пользователя

Страница: 37 / 134

37
Maintenance Procedures
Installation
IND100078-42
Access Actuator Lift Drivers, Tilt Motor and Sensors (Table Model)
This procedure allows you to get access to the main electronics and mechanics that controls the Tilt, Lift functions of the Chart &
Planning Table (hereby referenced as unit). There should be no regular need to access these elements unless there is a worn out
part, technical difficulties or in the event of service situation onboard. All parts are easy replaceable.
Note: Illustrations below may deviate slightly from written instructions (based on how the unit was delivered/tested prior to actual
installation onboard occurs). All procedures should be performed by a skilled technician that can interpret the physical parts and
correctly identify them on the illustrations below for correct installation).
▼1: First you need to remove the two Top Ceiling Covers on both sides of the Table Stand as illustrated. Each cover has 6 screws.
▼2: Remove 10 screws on Top Side Front/Back Covers as indicated to reveal the main control electronics w/PCB/Mounting Bracket.
Opposite side
▼3: Locate 4 screws to loosen the Mounting Bracket that contains the Drivers, Electronics and Sensors. Disconnect all cables in order
to extract out the entire bracket as shown below. Reverse the procedure to mount/connect it again.