EMBRON Hatteland X Series, Руководство пользователя

Страница: 77 / 134

77 User Controls
OSD Menu Functions
IND100064-48
Input Source Settings
Allows you to assign the defined inputs to a physical reference to the available signal sources
connected to the unit (example; you can assign “DisplayPort” as “Main Input”). The contents of this
submenu and choices are listed below. Note: Switch time between sources is ~5 sec.
|---2---
Input Source Settings > Main Input
Whatever chosen as “Main Input” will be used as reference throughout the OSD Menu.
Available sources are as listed below*
* For current models: “DisplayPort”, “HDMI1”, “HDMI2” or “HDMI3”.
* For HW00 models: “DisplayPort”, “HDMI”, “DVI” or “VGA”.
|---2---
Input Source Settings > Second Input
Whatever chosen as “Second Input” will be used as reference throughout the OSD Menu.
Available sources are as listed below*
* For current models: “DisplayPort”, “HDMI1”, “HDMI2” or “HDMI3”.
* For HW00 models: “DisplayPort”, “HDMI”, “DVI” or “VGA”.
|---2---
Input Source Settings > Third Input
Whatever chosen as “Third Input” will be used as reference throughout the OSD Menu.
Available sources are as listed below*
* For current models: “DisplayPort”, “HDMI1”, “HDMI2” or “HDMI3”.
* For HW00 models: “DisplayPort”, “HDMI”, “DVI” or “VGA”.
|---2---
Input Source Settings > Fourth Input
Whatever chosen as “Fourth Input” will be used as reference throughout the OSD Menu.
Available sources are as listed below*
* For current models: “DisplayPort”, “HDMI1”, “HDMI2” or “HDMI3”.
* For HW00 models: “DisplayPort”, “HDMI”, “DVI” or “VGA”.
|---2---
Input Source Settings > Auto Source
Turns on or off the internal automatic detection of incoming signals and when found stops and show
this signal source on the screen. If no source is connected physically, the function will loop through
all inputs forever. Available sources are as listed below:*
* For current models: “DisplayPort”, “HDMI1”, “HDMI2” or “HDMI3”.
* For HW00 models: “DisplayPort”, “HDMI”, “DVI” or “VGA”.
Settings as follows:
“On” = Loops until a valid signal source is found and stops. “On” is Factory default.
“Off” = No automatic detection loop will occur. User has to set manually.
Unit will enter Sleep mode.
● Switch time for next source is ~5 sec.The longest auto detection time is ~1minute from 1st source to last source.