GB-2
9. In line with agricultural Trade Association Regu-
lations only persons over the age of 17 may work
on their own with electric hedge trimmers. Use is
permitted for persons over 16 years if the work is
carried out under the supervision of adults.
10. We would recommend that safety clothing is
worn during the work and that eyes, ears, hair,
hands and feet are fully protected. Protective
gloves should also be worn.
11. Ensure that the motor of your hedge shears can
not be switched on by mistake when you put it
down after work or when you are going to clean
the device. Never forget to unplug the mains
supply!
12. Check the cutting unit regularly for damage and
if damage is discovered, the cutting unit should
be properly repaired.
13. Be aware of your responsibility as user towards
third parties in the working area.
14. The trimmer must be properly checked and
serviced. If the blades get damaged they should
only be exchanged in pairs. In the event of
damage from impact, specialist’s inspection is
essential.
15.Only use extension leads which have been
authorised for outside use. These flexes must
not be lighter than PVC covered flex conforming
to 227 IEC 53. They must be water spray pro-
tected. Damaged cables of this unit are only to be
replaced by a service station designated by the
manufacturer as special tools are necessary.
Equipment which will be used in different outside
loca-tions should be connected via residual-
current - operated current breakers.
16.Ensure that the equipment is stored safely after
use in such a way that the blade cannot be
touched.
17.When using the equipment, hold it securely with
both hands, stand firmly and ensure that you
have sufficient working space. There should be
no people, animals or objects within the working
area. Select the cutting height so that the blade
does not make contact with the ground and you
can operate the equipment from a secure
position.
18.Take care when transporting the equipment (only
with blade cover!).
19.For initial use of the hedge trimmer we would
recommend that in addition to reading the
operating instructions, you also seek a practical
demonstration from an expert.
20. Always ensure that all protective devices and
handles are properly fitted. Never attempt to use
an incomplete machine.
21.The use of the hedgetrimmer is to be avoided if
other persons, above all children, are within the
working area.
22.Familiarize yourself with the working area and
pay attention to possible dangers which you
might not be able to hear due to the noise of the
machine.
5. Before use
Mounting the bow-type handle
(Fig. 1)
If there are screws fixed to the mounting points, remove
these first.Then, remove the shear protector and put the
bow-type handle from the front (as shown in Fig. 1) over
the shearing system, and put it into the relief of the hedge
shears’ housing. (If necessary, pull the lower ends
of the handle slightly apart.) Take care that you do not
squeeze the two parts of the bow-type handle. To fasten
the bow-type handle screw the two included screws
through the openings in the handle into the threaded
holes of the housing and fasten them tightly.
Protection shield
(Fig. 2)
If screws are fastened to the bottom plate, remove these.
Fasten the hand protector with the two included screws
to the bottom plate.
Power connection
The machine can only be connected to a single-phase
a.c. current connection. The machine is protectively
insulated in accordance with classification II of VDE
0740. Before using the machine ensure that the mains
current agrees with the operating voltage data on the
machine’s identification plate.
Power Circuit Breaker:
Machines which will be used in different outside
locations must be connected to a Power Circuit
Breaker.
Securing the extension lead
(Fig. 5)
Only use extension leads suitable for outside use. The
cross section of the wire (max. length of extension cord:
75m) must be at least 1,5 mm2. Secure the equipment
flex to the extension lead by means of a loop (Fig. 5).
Extension leads longer than 30 m will reduce the
performance of the machine.
6. Instructions for use of the equipment
Do not use the trimmer in rain or for cutting wet hedges!
Check the hedge trimmer flex and its connections
before each and every use for visible signs of
damage (disconnect the power plug)! Do not use a
faulty flex.
Gloves:
Protective gloves must be worn when using the
hedge trimmer.
7. Switching on/off the hedge shears
(Fig. 3)
Please be sure to stand safely when you switch the hedge
shears on. This hedge shears have a 2-hand safety
switch. To switch on the hedge shears one of the switch
bars on the hand grip (A or B) and the switch on the
bow-type handle (C) must be held down. To switch the
device off release both switches. The motor is already
turned off if one of the two switches is released.
8. Maintenance
Always disconnect the plug from the power socket
before commencing any work on the machine.
