Eaton XN-GW Series, Руководство пользователя

Страница: 43 / 206

4 Technical features
4.5 Address setting
XI/ON: XNE-GWBR-2ETH-IP 09/2011 MN05002007Z-EN www.eaton.com
43
4.5.6 Address setting via PGM-mode
The PGM-mode enables the access of I/O-ASSISTANT to the gateway’s network settings (see
also Chapter 4.5.8 Address setting via the software "I/O-ASSISTANT", Page 45).
In order to activate the PGM-mode, the DIP-switch "MODE" is set to "ON", the address swit-
ches 2
0
to 2
7
to address "4" (see Table 6: Combinations for the address-switch settings,
Page 38).
The DIP-switch-settings are stored in the module’s non-volatile EEPROM.
LED-behavior
During it’s start-up, the module waits for the address setting via DHCP-/BootP-server. This is
indicated by the red flashing "MS" LED. The LED begins to flash green, as soon as the address
setting via the server is completed. The station is ready for communication.
Figure 27:
PGM
Note
In the PGM-mode, all network settings (IP address, subnet mask, etc.) are read from
the module’s internal EEPROM.
Attention
After every change of the address-mode, a voltage reset must be carried out.