Eaton Rapid Link 5, Руководство пользователя, Страница: 97 / 249

3 Installation
3.4 Power bus
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
93
3.4.1.3 Installing the end piece
▶ First slide the lower (shorter) part of the RA-C1-END1 ribbon cable end
piece onto the prepared flexible busbar.
▶ Slot the individual conductors into the insulation channels in the ribbon
cable end piece as far as they will go.
▶ Join the upper and lower sections using the two clamping screws.
Installed correctly, the flexible busbar offers degree of protection IP65.
Figure 52: RA-C1-END1 ribbon cable end piece
3.4.1.4 Flexible busbar junction connections
The supply and outgoer modules can be installed at any point along the flexi-
ble busbar without interrupting the busbar’s conductors. The connection is
made with contact screws.
Figure 53: Pin assignment of the
Flexible busbar junction
RA-C1-PLF1
Pin Function Wire number
(7 x 4 mm
2
)
1 L1 1
2 L2 2
3 L3 3
4 N 4
5 +24 V
1)
5
6 0 V
1)
6
PE PE yellow/green
1) Not used on RAMO5 and RASP5.
L2 L3 N L1 PE