Eaton Rapid Link 5, Руководство пользователя, Страница: 123 / 249

4 Operation
4.3 Manual control
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
119
4.3 Manual control
RAMO5 and RASP5 Rapid Link 5 modules come with a manual controller
(local controller) as standard. This controller is made up of a key switch and,
in the case of RAMO5-W and RASP5, of a direction selector switch.
The manual control allows:
• a simple commissioning,
• local operation during setup and maintenance,
• manual operation of a single drive unit with the overall system in
Auto mode,
• secure (interlocked) manual operation within an area secured with
limit switches (
￫ Section 2.9, Sensor inputs, page 61).
Figure 73: Key-operated switch
The key switch has three different positions.
￫
The key is maintained in all switch positions and can be inserted
and removed in all positions.
Position Function Description
Automatic
mode Automatic operation through
Manual mode Local operation, even without AS-Interface parameters.
Start enable is issued using the direction selector switch (FWD, REV) on
RAMO5-W… and RASP5 units.
On RAMO5-D… units, the start enable signal is sent using the key switch.
(Manual position).
OFF/RESET Off
Reset
command In this position, RAMO5 and RASP5 do not execute any control commands,
regardless of the source of the control commands.
0
I
II
OFF/RESET