Eaton Power Xpert Gateway 200E, Руководство пользователя и инструкция по установке

Страница: 60 / 212

CHAPTER 8 - PXG200E CONFIGURATION WEB PAGE
EATON PXG200E User Manual • IM02603001E Rev 5, 11-May-2012 • Firmware Version 5.03:3835 52
Adding a New Main - Step-By-Step
To add a new Main to the system, follow these procedures:
1. Click on the button (Figure 45, A) in the device list of the PXG200E
configuration web page.
Figure 45
2. Select “Main” from the “Create Which Device” drop-down menu
(Figure 4 6 , A) . Note that if there are no Buses installed on the
PXG200E, “Main” and Bus” are the only devices you will find on the
drop-down menu. If there is at least one Bus installed on the PXG200E,
there will be a variety of devices listed on the “Create Which Device”
menu. Some of the devices that are available are listed in the
Supported Device List on page 197 . This list was current when this
manual was published. The most current list is available on
www.eaton.com/pxg .
3. Click on the button (Figure 4 6 , B) to proceed to Step 5 if you are
satisfied with your selection.
4. Click on the button (Figure 4 6 , C) to go back to Step 1 if you wish
to change the selection.
Figure 46
PXG200E_038
A
PXG20E_039
A
B
C
RETURN