Configuring an EZ-NET network
For more information visit:
www.EatonElectrical.com
MN05013005E
99
Configuring an EZ-NET network
The EZ-NET network can only be configured from station 1.
Requirement:
All stations are correctly connected to the network and the
termination resistors have been connected.
All stations have a power supply and are in STOP mode. The
POW LED is permanently lit. The NET LED is permanently lit.
X
Proceed to the CONFIGURE menu item and press the
OK
button.
You will be asked to acknowledge whether you want to
configure the system.
X
Press the
OK
button.
The message on the left appears:
All NET LEDs on the stations which are assigned station
numbers higher than 1 (2 to 8) switch to the OFF state of EZ-
NET.
As soon as the configuration has been successfully
completed, the NET LEDs on all stations flash. The EZ-NET
network is ready for operation.
If you want to overwrite the station address press the
OK
button. The configuration can be aborted by pressing the
ESC
button.
J
If the connected stations are configured, all stations
automatically switch to the STOP mode.
NET
PARAMETERS...
STATIONS...
CONFIGURE
CONFIGURE?
CONFIGURATION
IN
PROGRESS.
J
An error message will appear if a station is assigned a
station address which does not correspond to the physical
location in the station list.
ERR: ID-CONFLICT
CONFIGURATION
CONFIGURATION ?
