Dräger Infinity Delta, Инструкция по эксплуатации

Страница: 100 / 614

4-6 D
ELTA
/D
ELTA
XL/K
APPA
VF8
4 A
DMISSION
, T
RANSFER
,
AND
D
ISCHARGE
Synchronizing the Monitors
To provide a complete and successful transfer of information, you must check that the
date and time of the source and destination monitors are identical. Trend data that is
copied from the source monitor 24 hours before or five minutes after the destination
monitor time is transferred without interruption. If you attempt to transfer data that
falls outside this time window, a banner appears requesting you to confirm the
transfer.
Network Data Transfer
To transfer data over the network, you must interrupt patient monitoring temporarily
by putting the source monitor in standby mode. The monitor saves both patient and
monitor settings until you exit standby and resume monitoring the same patient. To
transfer data over the network:
Transferring data over the network
1. Press the fixed key
Menu
. The main menu appears.
2. Scroll to
Standby
and click. The screen goes blank except for the following
message: Standby: Press Main Screen to resume monitoring.
3. Press the
Menu
fixed key at the destination monitor.
4. Click on
Admit/Discharge
.
5. Click on
Transfer
to display the Transfer Patient Data menu. If you are
transferring data from outside the destination care unit, proceed with step 6.
Otherwise proceed with step 8.
6. Click on
Select Care Unit to transfer from
. A list of care units appears (if
you are monitoring only one care unit, this item is ghosted).
7. Click on the care unit from which you are transferring data. The selected unit
appears next to
Care Unit
.
8. Click on
Select Bed to transfer from
to display beds currently in standby.
9. Click on the source bed to display it on the menu.
10. Click on
Start Transfer to this bed
.
11. Click on
Transfer to this bed
to transfer patient data and display the
message, Transfer In Progress , or on
Cancel
to return to the previous menu.
12. Press the
Main Screen
fixed key on the source monitor to exit standby mode.