Docomo N-09A, Инструкция по эксплуатации

Страница: 57 / 572

55 Continued on next page
Vo
ice/Videophone Ca
lls/PushTalk
● If a videophone call is not connected
When a videophone call is not connected, the cause
of the failure appears.
z
The cause may not appear depending on the
situation.
z
Depending on the type of the other party’s phone or
network service subscription, the reason may not
accurately reflect the other party’s actual status.
z
If the videophone call is not supported, your call is
automatically switched to a voice call when you set
“Auto redial as voice” to “ON”. However, the
videophone may not work properly if you call an
ISDN synchronous 64 KB access point, 3G-324M-
incompatible ISDN videophone (as of April, 2009)
or if you dial a wrong number. Call charges may
apply.
Switching a Voice/
Videophone Call during a Call
z
You can use this function with terminals compatible
with voice call/videophone call switch.
z
You can switch calls only when you are the caller.
z
To switch calls, the receiver needs to set “Ntfy
switch-mode” beforehand.
→ p.74
<Example: To switch a voice call to a videophone
call>
1
In-call screen (p.52)
X
d
(V.phone)
X
“YES”
During switching, a screen appears indicating
that the calls are being switched, and voice
announcement is played.
■ To switch a videophone call to a voice call
X
Videophone in-call screen (p.52)
X
u
(FUNC)
X
“Change to voice”
Display Cause
Check number
then redial The dialed phone number is
not in use
Busy The line is busy
• This message may also
appear during packet
communication, depending
on the other party’s
terminal.
Busy with packet
transmission The other party is using
packet communication
Out of service
area/power off The other party is out of
range or the phone is turned
off
Your call is being
forwarded The call is being forwarded (a
videophone call is made
when the forwarding number
is for a 3G-324M-compatible
videophone)
Redial using voice
call The forwarding phone is not
compatible with videophone
Please activate
caller ID before
dialing again The other party has set the
Caller ID request service
This number is not
available The other party has set the
Nuisance call blocking
service
Upper limit has
been exceeded
Connection failed The upper limit set for a Limit
billing plan (Type Limit or
Family Wide Limit) is
exceeded
Connection failed You attempted to connect
without notifying your caller
ID (when dialing into
visualnet, etc.)
• This message may also
appear in other situations.
Set Caller ID Notification to
“ON” and retry.
Please make your
call from the
i-mode web page You attempted to make a
videophone call to watch
V-live without browsing the
i-mode official site
N
z
It takes about 5 seconds to switch the calls. Note
that the signal quality may affect the switching
time.
Digital communications
charges apply after this
screen appears.