Digi IX14, Руководство пользователя

Страница: 79 / 828

Interfaces Wireless Wide Area Networks (WWANs)
IX14 User Guide 79
For example, to set Initial connection time to ten minutes, enter 10m or 600s .
The default is 60 seconds.
12. Optional active recovery configuration parameters:
a. Change the Interval between connectivity tests.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format
number { w|d|h|m|s }.
For example, to set Interval to ten minutes, enter 10m or 600s .
The default is 15 minutes.
b. If more than one test target is configured, for Success condition , determine whether the
interface should fail over based on the failure of one of the test targets, or all of the test
targets.
c. For Pass threshold , type or select the number of times that the test must pass after
failure, before the interface is determined to be working and is reinstated.
d. For Failed attempts , type the number of probe attempts before the WAN is considered to
have failed.
e. For Response timeout , type the amount of time that the device should wait for a response
to a probe attempt before considering it to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format
number { w|d|h|m|s }.
For example, to set Response timeout to ten minutes, enter 10m or 600s .
The default is 15 seconds.
13. (Optional) Repeat this procedure for IPv6.
14. Click Apply to save the configuration and apply the change.

Command line
Active recovery can be configured for both IPv4 and IPv6. These instructions are for IPv4; to configure
IPv6 active recovery, replace
ipv4 in the command line with ipv6 .
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new interface, or edit an existing one:
n
To create a new interface, see Configure a Wireless Wide Area Network (WWAN) .
n
To edit an existing interface, change to the interface's node in the configuration
schema. For example, for a interface named
my_wwan , change to the my_wwan node
in the configuration schema: