Digi IX14, Руководство пользователя

Страница: 421 / 828

Services Enable service discovery (mDNS)
IX14 User Guide 421
l
any : No limit to IPv6 addresses that can access the mDNS service.
d. Click

again to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the IX14 device:
a. Click Interfaces .
b. For Add Interface , click

.
c. For Interface , select the appropriate interface from the dropdown.
d. Click

again to allow access through additional interfaces.
n
To limit access based on firewall zones:
a. Click Zones .
b. For Add Zone , click

.
c. For Zone , select the appropriate firewall zone from the dropdown.
See Firewall configuration for information about firewall zones.
d. Click

again to allow access through additional firewall zones.
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the mDNS service:
(config)> service mdns enable true
(config)>
4. Configure access control:
n
To limit access to specified IPv4 addresses and networks:
(config)> add service mdns acl address end value
(config)>
Where value can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any : No limit to IPv4 addresses that can access the mDNS service.
Repeat this step to list additional IP addresses or networks.